This website uses cookies

Read our Privacy policy and Terms of use for more information.

In partnership with

A delivery truck backs along a marked jobsite route while a spotter controls the exclusion zone beside a wooden THE DIG DAILY DOSE sign.

Set the backing decision before the driver moves

A reverse alarm is not a route plan. We would keep the truck stopped until the driver knows the path, the spotter owns the move, and everyone knows what ends it.

The 7 Stocks to Own Before the OpenAI IPO

OpenAI is about to go public, and it could bring a new wave of investor attention to artificial intelligence.

But you don’t have to wait for the IPO to invest in the AI boom. Public companies are already supplying the chips, cloud infrastructure, data centers and software that AI runs on.

MarketBeat’s free report, The 7 Stocks to Own Before the OpenAI IPO, reveals the 7 stocks set to win when OpenAI goes public.

Get the full list before the IPO hits the headlines.

OSHA's construction backover standards page explains when a vehicle with an obstructed rear view must use a reverse signal alarm or a signaler. The field setup still has to keep people out of the blind area and give the driver a clear stop condition.

Walk it before the wheels turn

  1. Trace the reverse path. Point out the travel lane, pinch points, swing areas, pedestrian crossings, and the place where workers and parked equipment must stay out. Change the plan if the driver cannot hold that route.

  2. Name one spotter and one signal set. Driver and spotter should agree on the signals before the move. The spotter needs visual contact with the driver and no competing task.

  3. Say what stops the truck. Check the required alarm or signaler control. If visual contact breaks, the route changes, or another crew enters the zone, stop and reset the plan.

Put the route, exclusion zone, spotter, and stop condition in the free Construction Risk Radar.

Two source points worth carrying into the briefing

OSHA's backing safety guidance says the driver should stop immediately when visual contact with the spotter is lost and the spotter should have no other duty during the move. OSHA identifies 29 CFR 1926.601(b)(4), 1926.602(a)(9)(ii), and 1926.959(a)(3) for backing with an obstructed rear view.

The latest BLS fatal injury release reports 1,032 deaths among construction and extraction workers in 2024. Across all workers, transportation incidents remained the most frequent fatal event category.

Before the next truck reverses, have the driver and spotter point to the route, the exclusion zone, the signals, and the stop condition. If one is missing, leave the vehicle in place.

Source note: OSHA backover standards and solutions pages, plus the BLS 2024 Census of Fatal Occupational Injuries release, reviewed November 12, 2026.

Send this note to the person assigning the next spotter. Your personal referral link is below.

Recommended for you

View all
caret-right